Publicité
EN IS THERE A PROBLEM ?
PROBLEM
There is no steam.
The appliance is not plugged in, or not
switched on.
The water level is too low.
The steam pump has not been primed.
You are using the appliance for the
first time.
The water tank is not fully in place.
The appliance is on standby mode.
The appliance does
It is not plugged in, or not switched on.
not heat.
The appliance is on standby mode.
Water leaks.
The water tank is not fully in place or the
stopper is not closed properly.
Steam rate decreases.
Calc Sealing
The steam leaves stains
You are using water with additives.
on the fabric or the
appliance spits
The appliance has not been cleaned
enough after the descaling operation.
You are using other liquids than white
vinegar to descale the product.
Appliance steams
The steam trigger is on the lock position. Unlock the steam trigger.
continuously.
POSSIBLE CAUSES
SOLUTIONS
Check that your appliance is correctly
plugged in and switched on.
Unplug your appliance and refill it.
Press the steam trigger continuously for
a few seconds to begin steaming.
Press the steam trigger continuously for
a few seconds to begin steaming.
Ensure that stopper is closed and that
the water tank snaps when put into
place.
PLEASE REFER TO THE 'STANDBY'
section.
Plug in your appliance and switch on.
PLEASE REFER TO THE 'STANDBY'
section.
Ensure that stopper is closed and that
the water tank snaps when put into
place.
Refer to 'ANTI CALC section in
instructions for use.
Never add any additive in the water
tank.
Read carefully the 'ANTI CALC' section
in instructions for use.
Use only white vinegar during 'ANTI
CALC' procedure.
19
Publicité
