Teac VRDS-701 Mode D'emploi page 10

Connections (back) (continued)
Synchronizing external devices with
power operations of this unit (trigger
function)
The power of a connected preamp or another device that supports
trigger functions can be synchronized with the power operations of
this unit.
Use commercially-available mono mini plug cables for connections.
12V TRIGGER connectors
OUT
When this unit is turned on, it outputs 12 V.
By connecting this unit's TRIGGER OUT connector to a power
amplifier, subwoofer or other device that supports trigger
input, the power supply of that device can be synchronized
with the power operations of this unit.
IN
Connect this to the trigger output connector of a preamp or
other device.
This will make the power operation of that preamp or other
device control this unit, putting it in standby and turning it
on.
VRDS-701
10
ATTENTION
o To use the trigger input function, set this unit's STANDBY/ON
switch to ON.
o When connecting both IN and OUT, be careful not to cause a
trigger loop in the entire system.
Device that supports trigger input
(e.g., AP-701 or power amplifier)
Mono mini plug cable
V
Complete all other connections before turning
the unit on.
o Carefully read the manuals of the devices that you are
connecting and follow their instructions when making
connections.
o Do not bundle connecting cables with power cords. Doing
so could cause noise.
o Connect all plugs completely.