Philips FC6149/02 Mode D'emploi page 8

English
8
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding
electromagnetic fields (EMF). If handled properly and according to the
instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
preparing for use
installing the charger
Attach the charger to the wall as shown in the figure. (Fig. 2)
1
If you attach the charger to the wall, the space between the screw holes
has to be 12cm.
You can also place the charger on a horizontal surface (e.g. a table
2
or desk) (Fig. 3).
Wind excess mains cord around the reel in the back of the charger
3
and pass the cord through the slot (Fig. 4).
Charging the appliance
Charge the appliance for at least 16 hours before you use it for the first
time.
Make sure the appliance is switched off.
1
Put the adapter in the wall socket.
2
Place the vacuum cleaner on the charger (Fig. 5).
3
Make sure you place the opening in the back of the vacuum cleaner
-
on the hook of the charger (Fig. 6).
The charging light goes on to indicate that the appliance
,
is charging (Fig. 7).
Note: The charging light stays on as long as the appliance is in the plugged-in
charger.
Note: The charging light does not give any information about the battery
charge level of the vacuum cleaner.