ETNA A2793RVS Notice D'utilisation page 43

YOUR COFFEEPADMACHINE
CAUSE SOLUTION
There comes less or no coffee at Remove the cremamaker by pushing it out, from below,
all out of the coffeeoutlet. with a blunt object like a pen or the back of a teaspoon
and rinse it with warm water. One grain of coffee can
cause it to be blocked.
Check if the coffee-outlet is clogged and if necessary
clean it.
Check the position of the taste-selector.
We advise to loosen the coffee in the coffeepads before
you place them in the machine. This will ensure a
better transit of the water and will give a finer layer of
coffeecrema.
Coffeepaddrawer won't open You can solve the vacuum yourself by decompressing the
(vacuum). appliance using the valve inside the small hole on the
appliance (see "I" on page 5).
Procedure: Make sure that the waterreservoir is placed in
the appliance. Put a thin, blunt object inside the hole to
activate the valve. Keep pressing it during several seconds
until the water stops flowing back into the waterreservoir
and both pilot lamps (red and green) light up constantly.
Careful: the water that is being pumped back, is hot.
You have succesfully decompressed the appliance.
After you can open the coffeepaddrawer again, you must
clean the cremamaker and the multi-padholder. If
you do not clean the parts, the cause of the vacuum will
not be solved and at re-use the appliance will get locked
again.
Cleaning the cremamaker: Remove the cremamaker by
pushing it out, from below, with a blunt object like a pen
or the back of a teaspoon and rinse it with warm water.
One grain of coffee can cause it to be blocked.
GB 18
7 Faults YOUR COFFEEPADMACHINE
CAUSE
The lock does not work - the pilot
lamp keeps blinking.
7 Faults
SOLUTION
Check if the coffeepad(s) has (have) been placed
correctly.
Coffeepaddrawer is not locked, open the drawer and lock
it again.
Check the multi-padholder - at the back there should be
a protrusion sticking out, when this has broken off the
machine is not able to make coffee. Order a new multi-
padholder at an authorised technical service centre.
GB 19