Brandt TI1SLIM Manuel D'instruction page 26

b) Troubleshooting
Below you will find the inspections recommended for the defects encountered most often:
Do not dismantle the machine yourself to avoid any danger or deterioration of the
induction cooker.
Problems
After plugging the machine in the indicator for the
Start/Stop key does not light up and there is no display
on the screen.
The Start/Stop key indicator light comes on but
heating does not start.
The machine stops heating abruptly when it is
operating.
Display of error E0
codes
E1
E2
E3
E4
E5, E6
E1-E3-E4
E0-E2-E5-E6
BRANDT FRANCE - Simplified Joint Stock Company with capital of 100,000,000 Euros
89/91 Boulevard Franklin Roosevelt - 92854 Rueil-Malmaison (France)
Points to be checked
•
Check the machine is correctly connected to the
electric socket.
•
Check that the switch, the plug and the fuse are in
good condition.
•
Make sure that the pans are compliant with use on
induction hobs.
•
Make sure that the pans are correctly placed on the
induction hob.
•
Call an engineer.
•
Let the machine cool.
•
Clear the air inlet and outlet.
•
Adjust the timer again.
•
Refer to the fault codes below.
•
The machine circuits are defective
•
The induction cooker has not detected a pan or the
pans on the induction cooker are not compatible
•
The induction cooker has overheated
•
The voltage is too high
•
The voltage is too low
•
Short-circuit
•
Inspect the product to resolve the problem before
any other approach
•
Contact Customer Service
26