Brandt TI1SLIM Manuel D'instruction page 24

•
Boiling Function
This function enables you to boil water. To use this function press the Boiling key (5). An
indicator light comes on above the key. The heating power is adjusted to 10 by default. After
about 7 minutes it turns itself down to 8 automatically. For this mode the heating time is set to
15 minutes. Pressing the +/- keys deactivates the mode.
Note: To avoid any risk of boiling over do not fill your pan to more than three quarters full.
•
Boost Function
The Boost key (6) makes it possible to put the machine on full power for 10 minutes and then
maintain a maximum power level without the machine or the cooking utensil overheating. An
indicator light comes on above the key. Pressing the +/- keys deactivates the mode.
•
"Keep Warm" (Maintien au chaud) Function
To keep your preparation at service temperature press the Maintien au chaud (Keep Warm) key
(1). An indicator light comes on above the key. The machine will automatically adjust itself to
the minimum power 1 and will stop after 120 minutes. To adjust the power again press the +/-
keys.
•
Timer
In order to use the timer just select a cooking mode and then press the Timer key (3). An
indicator light comes on above the key. The digital screen will then show "00:00". Within 4
seconds press the +/- keys to adjust the cooking time. Each press increases or decreases the
time by 1 minute. If you hold down the key the time will increase or decrease by 10 minute
increments. The timer can be adjusted from 1 minute to 180 minutes. Once the time has
elapsed the digital screen will display "H" and a beep will be heard. The system will stop
automatically. To change the time during use press the Timer key (3) again and then press the
+/- keys. To stop the timer press the Timer key (3) for several seconds. The timer light will go
out.
•
Locking function
To lock all the control keys during cooking press the locking key (10). The "Lo" indicator will
appear on the screen.
In this situation only the Start/Stop key (7) can be used to turn off the machine. If you press
the Start/Stop key (7) in locking mode the screen will display "L" or "H" meaning that your
machine is turned off. To unlock the controls press the Start/Stop key (7) again and then press
the locking key for 3 seconds.
24