CLAS OC 9137 Mode D'emploi page 9

OC 9137
• Insert the drive unit with the threaded part into the hole previously drilled in the bumper (Fig.4).
• Screw the punch on the drive unit's thread (Figures 5+6).
s
g
4
e,
r
d
r
6
• Use a 3/8" ratchet wrench and then a monkey wrench to lock the punch from the outside. The punch
is pulled into the bushing as it is screwed (Figures 7+8).
A clean hole is created in the bumper without burrs by working from the outside towards the inside
(Fig.9).
8
REAR PARKING SENSOR PUNCH TOOL KIT VW/SKODA #2
(5 PCS)
5
7
9