Télécharger Imprimer la page

Beurer TS 26 XXL Mode D'emploi page 13

Masquer les pouces Voir aussi pour TS 26 XXL:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
• If the cable and control of the heat pad are not positioned properly,
there may be a risk of becoming entangled in, being strangled by, trip-
ping over, or stepping on the cable and control. The user must ensure
that excess lengths of cable, and cables in general, are safely routed.
• Please check this heated underblanket frequently for signs of wear
and tear or damage. If any such signs are evident, if the heated under-
blanket has been used incorrectly or if it no longer heats up, it must be
checked by the manufacturer before being switched on again.
• Under no circumstances should you open or repair the heated under-
blanket (including the accessories) yourself because faultless function-
ality can no longer be guaranteed thereafter. Failure to observe this will
invalidate the warranty.
• If the mains connection cable of this heated underblanket is damaged,
it must be disposed of. If it cannot be removed, the heated underblan-
ket must be disposed of.
• When this heated underblanket is switched on:
– Do not place any sharp objects on it
– Do not place any heat sources, such as hot water bottles, heat
pads or similar, on it
• The electronic components in the control warm up when the heated
underblanket is in use. For this reason, the control must never be cov-
ered or placed on the heated underblanket when it is in use.
• It is essential to observe the information relating to the following chap-
ters: Operation, Cleaning and maintenance, Storage.
• If you should have any questions about using our devices, please
contact our Customer Services department.
3. Intended use
CAUTION
This heated underblanket is designed for warming beds, only.
4. Operation
4.1 Safety
CAUTION
• This heated underblanket is equipped with a SAFETY SYSTEM. This sensor technology prevents the
entire surface of the heated underblanket from overheating by automatically switching off the heated
underblanket in the event of a fault. If the safety system has switched off the heated underblanket,
the temperature setting is not illuminated any more even when the heated underblanket is switched
on.
• Please note that the heated underblanket is not operable any more due to safety reasons in this
case and has to be sent to the service address indicated.
• Do not connect the defective heated underblanket with another control of the same type. This would
trigger a permanent switch-off via the control safety system.
13

Publicité

loading

Ce manuel est également adapté pour:

Ts 19