Troubleshooting - Silhouette Select DWC153BLSST Manuel Du Propriétaire

Occasionally, a problem is minor and a service call may not be necessary - use this
troubleshooting guide for a possible solution. If the unit continues to operate improperly, call an
authorized service depot or Danby's Toll Free Number 1-800-263-2629.
Problem
No Power.
Cabinet Temperature
too High
Condensation on the
cabinet and/or doors

Troubleshooting

Possible Cause What to do
A fuse in your home may
be blown or the circuit
breaker tripped
Power surge
Plug not fully inserted into
wall outlet
Temperature setting
Door not shut properly
or opened excessively
Exhaust vent is obstructed
Recently added a large
quantity of warm bottles
to the cabinet
High humidity conditions
in the home.
Door not shut properly
or opened excessively
11
Replace fuse or reset circuit breaker
Unplug the Wine Cooler, wait a
few seconds and then plug it back in
Make sure the 3-prong plug is fully
inserted into outlet
Verify the temperature control setting.
Adjust if neccessary
Ensure that the door is fully closed
and that the gasket is sealing against
the cabinets. Open the door only as
needed and for short periods of time
Verify there is nothing blocking the
front mounted exhausting vent
Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to stagger the
load introduction if possible
The condensation will subside once
humidity conditions return to normal
Ensure that the door is fully closed
and that the gasket is sealing against
the cabinets. Open the door only as
needed and for short periods of time