Publicité
Les langues disponibles
Les langues disponibles
from its socket in case of necessity.
Water connection
-
Ensure that the appliance is located near potable water connections.
-
Maximum water pressure is 3 bars (300k Pa)
-
The lower-right water pipe can be connected to the water main using the water hen.
-
The mechanical filter should be installed between the tap and pasta station in order
to prevent presence of iron.
Starting up:
-
Prior to first use, clean the appliance carefully
-
Fill the tank to the top with water and add washing up liquid. Turn the device on and
boil for few minutes. Remove the water once cold down then rinse in clean water.
Settings:
-
Set the main switch the button A in position 1 the display will read OFF and all
control lights will go off.
-
Hold the reset button H for around 3 sec to enter set-up mode.
-
Hold the water loading button B until the tank is filled with water. The water level
should be between the lower and upper indicators. After releasing the water loading
button B the flow of water will be stopped.
-
To set water temperature press button G, the previously set temperature will show
on the display.
-
Using button D and E set the desired temperature and at the end press
temperature button G to save the set value.
-
To change temperature while in use, press the temperature button G and raise or
low the temperature with buttons D and E.
Version 270114
22
Publicité
