Publicité
Les langues disponibles
Les langues disponibles
WARNING !
Operating your appliance can reach very high temperature. To avoid injuries and
burns do not use the appliance if it is damaged. Do no use spare parts not
provided with your appliance
DANGER ELECTRIC SHOCK !
In the event of bad installation, the appliance can be dangerous and cause injuries. The
electrical safety of this appliance is ensured only if it is correctly connected to an
efficiently earthed system in accordance with electrical safety regulations. The appliance
must be unpacked entirely before the connection.
5.2 Installation and use
WARNING !
Installation and maintenance must be only carried out by qualified technician.
Never let your appliance operating without supervision.
Always operate with dry hands.
Operating never move or tilt your appliance.
Operating instructions :
-
Remove all protective foils and packaging material prior to usage.
-
Place the appliance on a flat, solid, and heat-resistant surface, on its vertical
position. Never install your appliance on inflammable surface.
-
Do not install the appliance near open fireplaces or all hot sources.
-
If the appliance is to be located near a wall, it must be heat resistant to 80°.If the wall
is constructed of flammable material then a protective coating must be applied.
-
Arrange the appliance so that ventilations ducts are not blocked.
-
Place the appliance under a fume hood in order to draw away steam produced when
the appliance is in function.
-
Place the appliance so that the user can easily move to use it.
Electric connection
-
The plug must be protected by a circuit breaker of 16 A. Connect the appliance
directly to a wall plug socket. The use of adaptors, multiple sockets and/or
extensions is not recommended.
-
Before connecting the appliance to an electricity source, ensure that the voltage
and frequency values given on the panel correspond to those of the electrical
network. The maximum permissible voltage difference is +/- 10%
-
The appliance must be connected to the equipotential bonding system (grounding)
The connection clamp is located under the rear side of the device.
-
Place the device so that the plug is easily accessible and can be quickly removed
Version 270114
21
Publicité
