Ryobi RY36LMMX51A Traduction Des Instructions Originales page 6

operation. The telescopic handle must be fully
extended when setting up the product for use.
NOTE: The product will not function if the
telescopic handle is not fully extended and
the two latches are not in the correct position.
GENERAL MOWING TIPS
The run time of the battery depends on the
condition, length, and density of the grass.
Adjust the cutting height of the lawnmower to
suit the current condition of the lawn.
■ For best performance, always cut off one-
third or less of the total height of the grass.
■ When cutting long grass, reduce walking
speed to allow for more effective cutting
and a proper discharge of the clippings.
■ Do not cut wet grass; it will stick to the
underside of the deck and prevent proper
collection or discharge of grass clippings.
■ New or thick grass may require a higher
cutting height.
■ The product is designed to operate and cut
most effectively when moving forwards.
■ A higher cutting height extends the run
time of the battery pack.
TRANSPORTATION AND STORAGE
■ Turn off the product, and remove the
isolator key and the battery pack. Make
sure that all moving parts have come to a
complete stop. Allow the product to cool
down before storing or transporting.
■ Clean all foreign materials from the product.
Store the product in a cool, dry, and well-
ventilated place that is inaccessible to
children. Keep the product away from
corrosive agents such as garden chemicals
and de-icing salts. Do not store the product
outdoors.
■ For transportation in vehicles, remove
the isolator key, and secure the product
against movement or falling to prevent
injury to persons or damage to the product.
WARNING
Use extreme caution when lifting or tilting
the product for maintenance, cleaning,
storage, or transportation. The blade is
sharp; keep all body parts away from the
blade while it is exposed.
4 | English
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local
and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries by a
third party. Ensure that no batteries can come
in contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
batteries that are cracked or leaking. Check
with the forwarding company for further advice.
MAINTENANCE
WARNING
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
WARNING
Servicing requires
knowledge and should be performed only
by a qualifi ed service technician. Have the
product serviced by an authorised service
centre only. When servicing, use only
original replacement parts.
■ Turn off the product, and remove the isolator
key and the battery pack. Make sure that all
moving parts have come to a complete stop
before any cleaning or maintenance task.
■ You may make adjustments and repairs
described in this manual. For other repairs,
contact an authorised service centre.
■ Replace worn or damaged part for safety.
■ After each use, clean the product with a
soft, dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorised service centre.
■ Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure the
product is in safe working condition.
■ Be careful during adjustment of the product
to prevent entrapment of the fingers between
moving blades and fixed parts of the product.
■ When servicing the blades, be aware that
even though the power source is turned off,
the blades can still be moved.
manufacturer's
accessories and
extreme care and