Publicité
Les langues disponibles
Les langues disponibles
Auto air flow: the appliance automatically chooses
the air flow based on the temperature selected and
the environmental conditions. This selection is only
available in conditioning mode.
SILENT FUCTION (available in conditioning mode only
and on some models only)
By activating this function, the operating noise is further re-
duced. To activate it, press button
control. The display shows the relative symbol.
SELECT THE TEMPERATURE SCALE
The temperature can be displayed in °C or °F. To change the tem-
perature unit of measure select the air conditioning mode then
press both the decrease
about 3 sec.
SETTING THE TIMER
The timer allows the delayed start up or shut down of the appli-
ance. This function will prevent wasting electricity by optimising
the operating periods.
How to program delayed shut down
•
While the appliance is on in any operating mode, delayed
C11
shut down can be programmed.
C15
•
Press the
timer button (D7), the timer symbol is dispaly-
C8
ed and the hours light up.
C10
C14
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of warning/malfunctions.
Error messages are displayed on the appliance display.
IF ... IS DISPLAYED,
C3
C2
"Low Temperature"
(Frost prevention)
..WHAT SHOULD I DO?
The appliance is fitted with a frost protec-
tion device to avoid excessive formation of
ice. The appliance starts up again auto-
matically when the defrosting process is
completed.
(D6) on the remote
(D5) and increase
(D4) keys for
C5
C6
C7
C9
C12
C13
IF ... IS DISPLAYED,
C4
C1
..WHAT SHOULD I DO?
If this is displayed, contact your local au-
thorized service center.
•
Press the
numbers of hours to shut down appears on the display.
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer symbol stays lit.
C11
Once the set time is elapsed, the air conditioner goes into standby.
C15
To cancel the timer program, press the
twice. The timer symbol will go off.
C10
How to program delayed start up
C11
C14
•
Plug in the appliance and set to standby.
C15
•
Press the
C8
palyed and the hours light up.
C10
•
Press the
numbers of hours to start up appears. Start up can be pro-
grammed at any time within the 24 hours that follow.
C14
When the set time is elapsed, the appliance will start to operate
C11
in the same operating mode that was previously set.
C15
To cancel the timer program, press the
twice. The timer symbol will go off.
C10
C3
C14
C2
"Probe Failure"
(Probe damaged)
16
(D5) and
(D4) buttons until the desired
timer button (D7)
C8
C5
C6
C7
timer button (D7), the timer symbol is dis-
C9
(D5) and
(D4) buttons until the desired
C12
C3
C13
C2
timer button (D7)
C8
C4
C1
C3
C2
IF ... IS DISPLAYED,
"High Level"
(Internal tray full)
..WHAT SHOULD I DO?
Empty the internal safety tank following
the instructions in the section "End of
season operations".
C5
C6
C7
C9
C12
C13
C4
C5
C6
C1
C7
C9
C12
C13
C4
C1
Publicité
