Publicité
Les langues disponibles
Les langues disponibles
Cleaning and maintenance
6.4 Checking the installation
1. Make sure the solar panels are in the sunlight.
2. Clip an ammeter around the positive solar connection between the solar charge controller and the batteries.
3. Activate a consumer connected to the batteries.
4. Observe the ammeter for current flow from the solar charge controller to the batteries.
5. If no current flow is observed, recheck all connections and the fuse.
I
NOTE
It can take up to one minute for the solar charge controller to start charging, so there
may be a delay before current flow is registered on the ammeter.
7 Cleaning and maintenance
A
NOTICE! Damage hazard
• Never clean the solar panels with pressure washer.
• Do not use sharp or hard objects, abrasive cleaning agents or bleach during clean-
ing as these can damage the solar panels.
➤ Clean the solar panels with water and a soft cloth or sponge monthly. A mild, non-abrasive cleanser can be used
for removing stubborn residue.
➤ Clean the solar panels more frequently during drier months, as they may become covered in dust more quickly.
➤ Regularly check the exterior for cracks, missing or broken hardware.
➤ Replace sealants if necessary.
8 Troubleshooting
For troubleshooting refer to the installation and operating manual of the solar charge controller used in your appli-
cation.
9 Warranty
The statutory warranty period applies. If the product is defective, please contact your retailer or the manufacturer's
branch in your country (see dometic.com/dealer).
For repair and warranty processing, please include the following documents when you send in the product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Note that self-repair or non-professional repair can have safety consequences and might void the warranty.
14
GP-FLEX-55/110
EN
Publicité
