R&G DG0019 Instructions De Montage page 7


Enlever les 2 boulons arrowed in photos 17 and 18.

Positionner la grille de tuyaux en position puis fixer à l'aide des boulons d'origine, voir photos 19, 20
et 21.

Remonter tous les carénages latéraux comme à l'origine, mais ne pas fixer les serrages inférieurs.

Enlever les 2 clips J indiqués sur les photos 22 et 23.

Fixer tous les serrages inférieurs excepté les 2 indiqués sur la photo 24.

Fixer la grille de tuyaux au cache interne avant, à l'aide des 2 boulons M5 munis de rondelles et les
écrous M5 avec rondelles, voir photos 24 et 25. Ne pas trop bloquer – les écrous Nyloc fixeront la
position .

Vérifier que l'ensemble des caches et boulons sont correctement fixés avant de rouler.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes
which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer
acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those in R&G's
order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular
purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free of
charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not
affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a replacement or refund the
purchase money but shall not be liable if the Products have been modified or used or maintained otherwise than in accordance with R&G's
or manufacturer's instructions and good engineering practice or if the defect arises from accident or neglect. Other than identified above and
subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and
otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do
not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable
condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at
the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of discontinued products, unless
within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
Unit 1 Shelleys Lane, East Worldham, Alton, Hants GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 09/10/2015 (NSY)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com
DG0019
Email: info@rg-racing.com