Qilive Q.6317 Manuel D'utilisation page 9

Connecting the water inlet hose
Connect the cold water supply hose to a
threaded 3/4(inch) connector and make sure
that it is fastened tightly in place. If the water
pipes are new or have not been used for an
extended period of time, let the water run to
make sure that the water is clear and free of
impurities. If this precaution is not taken, there
is a risk that the water inlet can get blocked and
the appliance could be damaged.
Connecting the water outlet hose
Fit the drainage hose of your machine to the
drainage pipe without bending.
If the length of the hose is not sufficient, apply
to the authorized service for an extension
made from the same material as the original.
Remember that the length of the hose should
not exceed 4 m even when with an extension.
If the drainage hose is longer than 4 m, the
dishes will not be cleaned properly.
Secure your hose firmly to the drainage pipe to
avoid it coming off during the washing process.
How to drain excess water from hoses
If the sink is 1000mm higher from the floor, the excess water in hoses cannot be
drained directly into the sink. It will be necessary to drain excess water from hoses into
a bowl or a suitable container that is held outside and lower than the sink.
Water outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water
leaks. Ensure that the water inlet hose is not kinked or squashed.
Extension hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher
could be reduced.
Syphon connection
The waste connection must be at a height of between 50cm (minimum) and 100cm
(maximum) from the bottom of the dishwasher. The water drain hose should be fixed by
a hose clip.
5.3. ELECTRICAL CONNECTION
Information about the electrical connection can be found on the data plate located on
the inside of the door. This specification must match the electricity supply.
The dishwasher must be connected to an earthed socket.
The electric wall socket must be placed outside of the installation area to be easily
accessible after installing the dishwasher. Do not use an extension cord!
WARNING
Electrical cable replacements as well as repairs and maintenance relating to safety
or performance must be carried out by the manufacturer's service centre or someone
similarly professionally qualified.
Ensure that proper earthing exists before use.
9
min Ø40mm
EN