Qilive Q.6317 Manuel D'utilisation page 20

Turn on the appliance by pressing the Power button.
6.
EN
7. Press the Program button to select a desired "Wash cycle". (Note: Select the
program according to the type of load and degree of soiling, as described in the
"Wash Cycle Table".)
Press the Start/Pause button to start the cycle.
8.
Note: A click will be heard when the door is closed perfectly.
8.3. CHANGE THE PROGRAM
A cycle that is underway can be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must
be refilled (see "FILL IN THE DETERGENT" on page 14).
Press the Power button to cancel the current program.
1.
2. Turn the appliance on again and restart a new washing cycle (see the section
"Start a wash cycle").
Note: If you open the door during the wash cycle, the appliance will pause and emit
warning signals, the digital display will show "E1" and flash. When you close the door,
the machine will resume operation after 10 seconds.
The 5 program lights show the state of the dishwasher:
a) All program lights off --> standby
b) One of the program lights steadily on--> cycle running
c) One of the program lights blinking --> paused
Note: If all the lights begin to glimmer, this indicates the machine is out of order, please
turn off the mains power and water supply before calling a service.
8.4. FORGET TO ADD DISH
A forgotten dish can be added any time before the detergent cup opens.
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add forgotten dishes.
4. Close the door, the dishwasher will continue to work after ten seconds.
WARNING
It is dangerous to open the door when washing, because the hot water may scald you.
8.5. AT THE END OF A PROGRAMME
When the working cycle has finished, the digital display shows "---", then stop. When a
programme has ended:
1. Turn off the appliance using the Power button.
2. Turn off the water tap.
3. Open the door of the dishwasher.
Open the door carefully. Hot steam may escape when the door is opened!
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and
utensils while they are still hot and more susceptible to breakage. They will also dry
better.
Leave the dishwasher's door ajar and wait a few minutes before removing the dishes.
In this way they will be cooler and the drying will be improved.
8.6. UNLOAD THE DISHWASHER
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper basket. This will avoid water dripping
from the upper basket onto the dishes in the lower basket.
20