The affected items are
not corrosion resistant.
A program was not run
after dishwasher salt
There are rust
was added. Traces of
stains on cutlery
salt have gotten into
the wash cycle.
The lid of the softer is
loose.
The dishes were not
loaded correctly.
The program was not
powerful enough.
Not enough detergent
was dispensed.
Items are blocking the
The dishes are
movement of the spray
not clean
arms.
The filter combination
is not clean or is not
correctly fitted in the
base of wash cabinet.
This may cause the
spray arm jets to get
blocked.
Combination of soft
Cloudiness on
water and too much
glassware
detergent.
White spots
Hard water area
appear on
can cause limescale
dishes and
deposits.
glasses
Aluminium utensils
Black or grey
have rubbed against
marks on dishes
dishes
Detergent left in
Dishes block detergent
dispenser
dispenser
The detergent
Clogged detergent
dispenser lid
residue is blocking the
cannot be
catch
closed properly
Steam
Normal phenomenon
Avoid washing items that are not
corrosion resistant in the dishwasher.
Always run a wash program without any
crockery in the dishwasher after adding
salt. Do not select the Turbo function (if
present), after adding dishwasher salt.
Check if the softener lid is secure.
See "LOAD THE DISHWASHER
BASKETS" on page 15.
Select a more intensive program.
Use more detergent, or change your
detergent.
Rearrange the items so that the spray
arms can rotate freely.
Clean and/or fit the filter correctly. Clean
the spray arm jets.
Use less detergent if you have soft water
and select a shorter cycle to wash the
glassware and to get them clean.
Check water softener settings or fill
status of salt container.
Use a mild abrasive cleaner to eliminate
those marks.
Re-loading the dishes properly.
Wipe up the detergent from the catch.
There is some steam coming through the
vent by the door latch during drying and
water draining.
25
EN