Télécharger Imprimer la page

Qilive Q.6317 Manuel D'utilisation page 8

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
5. INSTALLATION INSTRUCTIONS
EN
WARNING
Electrical Shock Hazard!
Disconnect electrical power before installing dishwasher.
Failure to do so could result in death or electrical shock.
Attention
The installation of the pipes and electrical equipment should be done by professionals.
Keep this instruction manual in a safe place for future reference. If the appliance is
sold, given away or moved, please ensure the manual is kept with the machine, so that
the new owner may benefit from the advice contained within it.
Please read this instruction manual carefully: it contains important information
regarding the safe installation, use and maintenance of the appliance.
If the appliance must be moved at any time, keep it in an upright position; if
absolutely necessary, it may be tilted onto its back.
5.1. POSITIONING AND LEVELING
1.
Remove the appliance from all packaging and check that it has not been damaged
during transportation. If it has been damaged, contact the retailer and do not
proceed and further with the installation process.
2.
Check the dishwasher by placing it so that its sides or back panel are in contact
with the adjacent cabinets or even with the wall. This appliance can also be
recessed under a single worktop (see the Assembly instruction sheet).
3.
Position the dishwasher on a level and sturdy floor. If the floor is uneven, the
front feet of the appliance may be adjusted until it reaches a horizontal position
(the angle of inclination must not exceed 2 degrees). If the appliance is levelled
correctly, it will be more stable and much less likely to move or cause vibrations
and noise while it is operation.
Positioning the appliance
Position the appliance in the desired location. The back should rest against the
wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is
equipped with water supply and drain hoses that can be positioned to the right or the
left to facilitate proper installation.
Leveling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust
the height of the dishwasher, making it level. In any case, the appliance should not be
inclined more than 2°.
Note: The maximum adjustment height of the feet is 20 mm.
5.2. CONNECTION TO WATER SUPPLY
Connection to the water and electricity supplies should only be performed by a
qualified technician.
The dishwasher should not stand on top of the water hoses or the electricity supply
cable.
The appliance must be connected to the water supply network using new piping.
Do not use old piping.
8

Publicité

loading