Publicité
Les langues disponibles
Les langues disponibles
5 Getting started
WARNING
Danger due to electrical voltage and resulting fire hazard
The cables must not be kinked or trapped.
x
ATTENTION
Risk of malfunctions or defects of the device
Incorrect installation
Connect the cables to the set-top box in the correct order. Make sure that
x
the network cable engages audibly.
Interrupting the power supply during installation
Never disconnect the power to the set-top box box during installation or
x
when updating the software. This avoids possible damage.
5.1 Inserting the batteries into the remote control
1. Insert the batteries into the remote control (see Figure 2 on page 7). To
do so, press down the battery cover at the mark and slide it back
the battery compartment.
2. Place the batteries in the battery compartment
correct (see markings on the bottom of the battery compartment).
3. Insert the lug of the cover into the opening
and push the battery compartment cover forward
into place.
Figure 2: Inserting the batteries
, making sure the polarity is
on the battery compartment
until it audibly latches
P480 Hybrid CM | 7
, to open
Publicité
