Rowenta DW52 Serie Manuel D'utilisation page 4

SAVE THESE INSTRUCTIONS
FOR YOUR SAFETY PLEASE READ THESE
INSTRUCTIONS CAREFULLY AND KEEP THEM
FOR FUTURE REFERENCE.
This appliance complies with the technical rules and standards for
safety currently in force (Electromagnetic Compa ti-bility, Low Voltage,
Environnement).
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental ca pa-bilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety. Children must be supervised to ensure that they do not
play with the appliance.
• During the first few uses, a harmless odour and a small amount
of smoke may be given off. This has no effect on the use of the
iron and will disappear quickly.
• Warning ! The voltage of your electrical installation must
correspond to that of the iron (120V or 127 V). Connecting to
the wrong voltage may cause irreversible damage to the iron
and will terminate the guarantee.
• If it is absolutely essential to use an extension cable, choose a 15 amp
cord.
• If the electrical cord becomes damaged, it must be immediately
replaced by an Approved Service Centre to avoid any danger.
• The appliance should not be used if it has fallen, if it has obvious
damage, if it leaks or functions incorrectly. Never dismantle your
appliance : have it inspected by an Approved Service Centre, to avoid
any danger.
• Never immerse your iron in water !
• Do not unplug your appliance by pulling on the cord. Always unplug
your appliance: before filling or rinsing the water tank, before cleaning
it, after each use.
• Never leave the appliance unattended when it is connected to a power
source or if it has not cooled down for approximately 1 hour.
• Your appliance gives off steam, which may cause burns. Take extra
care especially when you are ironing close to the edge or on a corner of
your ironing board. Never direct the steam towards people or animals.
• Your iron should be used and placed on a flat, stable, heat-resistant
surface. When you put your iron onto its iron rest, make sure that the
surface on which you put it is stable.
5