Press Start/Pause Button to pause the machine when the door is closed,
Press Program Button for more than 3 seconds the machine will be in stand-by
state, then you can change the program to the desired cycle setting
(see the section entitled "Starting a wash program" ).
The Display window shows the state of the dishwasher:
a) Display window shows "-:--" ----------------------------------> stand by;
b) Display window shows "H:MM" and not blinking -------------> pause;
c) Display window shows "H:MM" and blinking ------------------------> run;
d) Display window shows "END" ------------------------> end.
NOTE
If you open the door during washing, the machine will pause. When
you and press the Start/Pause Button, the machine will keep on
working after 10 seconds.
If your model has broken remember function, the machine will go on to finish the
selected program after the power cut.
Forget to add a dish?
A forgotten dish can be added any time before the detergent dispenser opens. If
this is the case, follow the instructions below:
1. Press the Start/Pause button
2. Open the door.
3. Add forgotten dishes.
4. Close the door.
5 Press the Start/Pause button, the dishwasher will run .
.
24