GET SX1 PRO Guide D'installation page 5

6.
To protect the fuel tank, glue the
special sponge pad (included in the
kit) on the side of the GET ECU, as
shown in the figure.
7.
Connect the GET SX1 Pro ECU
to the original connector. Make
sure that the connector is inserted
correctly and that the latch is fully
engaged.
8.
Reinstall the battery tray now equipped with the GET
ECU. Reconnect the starter relay, reposition the battery in the
tray and secure it with the previously removed original rubber
band. Reconnect the battery.
9.
Connect the special cable
(included in the kit) to the GET ECU
main connector. Pass the cable up
to the front of the bike, attaching it
to the frame using the clamps (not
included in the kit).
10.
Reposition the tank and re-install the side panels, seat,
and all other components which were removed during the
preliminary steps.
EN
5