GET SX1 PRO Guide D'installation page 2

ENGLISH
A. PRECAUTIONS FOR CORRECT USE
Read all the instructions and warnings carefully before using
the GET SX1 PRO ECUs. Failure to read and/or observe the
instructions and warnings can lead to incorrect use of the
device or its malfunction, resulting in product damage and
personal injuries.
SX1 PRO KIT IS INTENDED ONLY AND EXCLUSIVELY
FOR RACING USE.
GENERAL WARNINGS
1. Follow the instructions described in this manual to prevent
vehicle damages.
2. Do not modify or replace the material supplied by GET.
3. Always make sure that no installed part can interfere with
the hot parts of the engine, the steering components or with
the rider.
4. The product is not a toy. Keep it out of the reach of children
and/or animals as it contains small sized components that
could be swallowed.
5. Do not use the product for purposes other than those
specified in these instructions.
6. Do not use high pressure washers on the product.
PRECAUTIONS FOR CORRECT USE
1. Always make sure that the GET SX1 Pro ECU is properly
installed and functional prior to use.
2. Never expose the device to temperatures above 70°C/158°F.
3. Install the unit when the engine is cold.
4. The SX1 Pro ECU not work properly if the original TPS sensor
is damaged or has been modified.
5. The RPM limiter threshold of the GET SX1 Pro maps is higher
than the threshold for the standard ECU.
6. To change the SX1 Pro injection map, it is necessary to use
GET Maya programming software (sold separately). Unlike
the other SX1 PROs, this ECU can only be programmed if it
EN
2