GET SX1 PRO Guide D'installation page 3

is installed on the bike. Use the GL-284-AA programming
connector (sold separately) to be able to work on the control
unit alone with the help of a 12V battery.
7. If the bike won't start or the engine runs roughly, make
sure the SX1 Pro ECU you have chosen is compatible with the
model and year of your bike, make sure that the ECU is properly
connected, and always perform a TPS calibration.
8. The original Mode button (blue) can be used to manage the
GET LC-GPA when installed. In order for the GET SX1 Pro ECU to
work properly, use only the GET SX1 CONTROLLER (included in
the kit) and the GET LC-GPA module (sold separately).
9. The GET ECU supports the connection of multiple
devices, such as SX1 CONNECT, SX1 CONTROLLER, LC-GPA,
QUICKSHIFTER, GPA SWITCH, SL-1 SMART LOGGER:
-to connect up to two devices, use the GL-264-AA harness
(included in the SX1 PRO kit).
-to connect up to four devices, use the GL-266-AA harness
(sold separately).
B. HOW TO INSTALL THE GET SX1 PRO
SX1 PRO is a fully programmable plug&play ECU. SX1 PRO is the
best solution for both stock and modified engines: it is possible
to adjust the calibration map either through the WiGET App by
using the SX1 CONNECT device, or with MAYA software.
WiGET App
The SX1 Pro ECU comes with two reprogrammable maps
developed by the GET R&D department:
- Map 1: Racing
- Map 2: Racing with GPA "Traction Control" Level 5.
3
EN