Human Touch WHOLEBODY ROVE PRO Manuel D'utilisation Et D'entretien page 5

ASSEMBLE THE CHAIR
Raise the Chair to the Upright Position
1. Plug the power cord into the rear of the chair and then into
a grounded wall outlet.
2. Turn the power switch located on the back of the chair base to
On. The chair automatically inclines to the upright position
(Fig.1).
3. Power off the chair, then unplug it.
Install the Calf Massager
1. Remove and retain the two clips from the calf massager
mounting posts located on the front of the chair by prying the
tongue of each clip outward to release it (Fig.2).
Clip
Mounting post
Electrical connector
2. Place the massager into position in front of the
chair, then connect the two air hoses and electrical
connector (Fig.3).
IMPORTANT: Match the air hoses by color.
humantouch.com
Fig.1
Fig.2
Air hose
Fig.3
6
3. Position the massager mounting brackets to the right of the mounting posts, lift the massager from the
floor, then slide the mounting brackets onto the mounting posts (Fig.4).
Post
Mounting bracket
Fig.4
7