American Standard 8337018 Manuel Du Propriétaire page 3

INSTALLATION INSTRUCTIONS
1
INSTALLATION OF MOUNTING BRACKETS FOR ALL WALL MOUNTED ACCESSORIES
• The WALL MOUNTED ACCESSORIES work best if secured to a wall stud or cross brace within the wall,
using the SCREWS (2) supplied.
• If the ACCEASAORY is to be installed on a tile or plaster wall, the ANCHORS (3) and SCREWS (2)
should be used.
• Determine desired height and location (optional) and mark a center line. Make sure the centerline is level.
Using the MOUNTING BRACKET (1) as a template, mark the two spots for the mounting holes.
If MOUNTING BRACKET (1) is secured to a stud or cross brace, drill small pilot holes for SCREWS (2).
• For installations on tiled walls or drywall, use TILE ANCHORS (3) and SCREWS (2) for securing
MOUNTING BRACKET (1) to wall. Drill two 1/4" diameter holes a minimum of 1-1/4" deep. Insert the
two TILE ANCHORS (3) flush with face of finished wall. Place MOUNTING BRACKET (1) over TILE
ANCHORS (3) and insert SCREWS (2) provided with a flat blade screwdriver. See illustration below.
• Secure MOUNTING BRACKET (1) to wall with SCREWS (2).
3
1
DRILL PILOT HOLE FOR
WOOD SCREW (2) OR
LEVEL
1/4" DIA. HOLE FOR
ANCHOR (3)
C L
3/4" (19mm)
FINISHED WALL
1
3/8" (9mm)
3