Thor Kitchen TMD2401 Instructions D'installation page 5

UNPACKING YOUR DRAWER
MICROWAVE
• Remove all packing materials from inside the Drawer Mi-
crowave. DO NOT REMOVE THE WAVEGUIDE COVER, which
is located on the top of the appliance.
Sealing Surface
Waveguide Cover
Oven Cavity
• Remove the feature sticker, if there is one. Check the drawer
for any damage, such as misaligned or bent drawer, dam-
aged drawer seals and sealing surfaces, broken or loose
drawer guides and dents inside the cavity or on the front
side of the drawer. If there is any damage, do not operate
the appliance and contact your AUTHORIZED SERVICER.
IMPORTANT NOTES TO THE INSTALLER
• Read the entire Installation Manual before installing the
Drawer Microwave.
• Remove all packing material before connecting the electri-
cal supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
IMPORTANT NOTES TO THE CONSUMER
Keep this manual with your Use and Care Manual for future
reference.
• As when using any microwave oven generating heat, there
are certain safety precautions you should follow. These
are listed in the Use and Care Manual. Read all and follow
carefully.
• Be sure your Drawer Microwave Oven is installed and
grounded properly by a qualified installer or service tech-
nician.
E
INSTALLATION GUIDE
CLEARANCES AND DIMENSIONS
• Dimensions shown in this manual must be used. Given
dimensions provide minimum clearance. Locate electrical
outlet in the shaded area in the upper left-hand corner of
the cutout.
• Contact surface must be solid and level. Pay special at-
tention to the floor on which the appliance will sit. The
floor of the opening should be constructed of plywood
strong enough to support the weight of the oven (about
100 pounds).
• Check location where the Drawer Microwave will be in-
stalled for proper electrical supply.
• Your appliance can be built into a cabinet or wall by itself
or under a gas or electric wall oven.
• Be sure that the clearance of the floor between the wall oven
and the Drawer Microwave is a minimum of 2" (50.8 mm).
• The microwave interior will easily accommodate a 9" x 13"
oblong dish or a bag of microwave popcorn.
This appliance must be grounded. In the event of an elec-
trical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
The Drawer Microwave is equipped with a cord having
a grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed and
grounded in accordance with the National Electrical Code
and local codes and ordinances.
WARNING: Improper use of the grounding plug can result
in a risk of electric shock. Do not use an extension cord. If
the power supply cord is too short, have a qualified electri-
cian or serviceman install an outlet near the appliance.
5
GROUNDING
INSTRUCTIONS
PERMANENT AND CORRECT INSTALLATION
3-Prong
3-Prong Plug
Receptacle
Ground
Receptacle Box
Grounding Pin