Thor Kitchen TMD2401 Instructions D'installation page 14

ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
• To reduce the risk of tipping of the drawer, the Anti-Tip block
must be properly installed located 14-13/16" (355.6 mm)
above the floor on which the appliance will sit. The 6" Anti-
Tip block must be provided by the installer. The Anti-Tip block
prevents serious injury that might result from spilled hot liquids.
• If the Drawer Microwave is ever moved to a different location,
the Anti-Tip block must also be moved and installed. When
installed to the wall, make sure the screws completely
penetrate the dry wall and are secured in wood or metal
so the block is totally stable. When fastening, be sure the
screws do not penetrate electrical wiring or plumbing.
Anti-Tip block
5" (127 mm)
INSTALLATION GUIDE
6"
(152.4 mm)
3-1/2"
(89 mm)
ELECTRICAL OUTLET
The electrical requirements are a 120 volt 60 Hz, AC only, 15
amp. or more protected electrical supply. It is recommended
that a separate circuit serving only this appliance be provided.
The Drawer Microwave is equipped with a 3-prong grounding
plug. It must be plugged into a wall receptacle that is properly
installed and grounded. Should you only have a 2-prong outlet,
have a qualified electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or elec-
trical instructions, consult a qualified electrician or service
person.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord
can reach.
Always check electrical codes for requirements.
Suggested electrical
outlet location*
14
Anti-Tip b
5" (127 mm)
4"
(101.6 mm)
E