Thor Kitchen TMD2401 Instructions D'installation page 10

30" DRAWER MICROWAVE STANDARD MOUNT
F
Figure 7: 30" Drawer Microwave Dimensions
KEY
A 21-5/8" (549.28 mm) unit width
B 4-11/16" (119.06 mm) cord recess width
C 1-3/4" (44.45 mm) cord recess height
D 21-7/8" (555.60 mm) unit depth without door
E 30" (762 mm) width of door face
F 15-7/8" (403.22 mm) height of door face
G 14-19/32" (370.69 mm) height of body
H 1-9/64" (29 mm) door thickness
I 15" (381 mm) auto drawer opening
J 4" (101.6 mm) cord recess depth
Figures 7 and 8 contain many 30" Drawer Microwave
measurements for reference when planning the drawer's
location.
This 30" Drawer Microwave can be installed below any
electric or gas wall oven.
* Can also be installed using an electrical outlet in an
adjacent cabinet within the area where the provided
electrical cord can reach. Power cord access hole in
cabinet should be a minimum 1-1/2" (38.1 mm) diameter
hole and deburred of all sharp edges.
IMPORTANT - Always allow sufficient power cord length
to the electrical outlet to prevent tension. Always check
electrical codes for requirements.
C
A
B
J
I
H
E
DESCRIPTION
Suggested electrical
outlet location*
G
J
D
KEY DESCRIPTION
A
B
C
D
E
F
G
H
I
J
K
L
M
N
10
B
D
E
G
H
G
M
Figure 8: 30" Drawer Microwave
Standard Mount Cutout
6" (152.40 mm) Anti-Tip block width
5" (127 mm) electrical outlet opening height
3-1/2" (88.90 mm) Anti-Tip block depth
4" (101.60 mm) electrical outlet opening width
22-1/8" (561.98 mm) minimum to
28-7/16" (711.2 mm) maximum opening width
14-13/16" (376.24 mm)
to bottom of Anti-Tip block
Allow 23/32" (18.26 mm) overlap
23-1/2" (596.90 mm) minimum depth
Allow 3/16" (4.76 mm) overlap
36" (914.4 mm) countertop height
Allow 1/8" (3.17 mm) overlap
19" (482.60 mm) to top of floor
30" (762 mm) cabinet minimum width
15-9/16" (395.27 mm)
opening minimum height
A
Anti-Tip block
C
F
I
N
Floor must
K
support 100 lb
(45.4 kg)
L
E