Noco GENIUS2 Guide D'utilisation Et Garantie page 8

1
1.) Mode Button Push to cycle through charging Modes.
2.) Overvoltage Error LED Illuminates solid Red; Battery Voltage is above
Protect voltage.
3.) Bad Battery Error LED Illuminates solid Red when connected battery will
not hold a charge.
4.) Reverse Polarity Error LED Illuminates solid Red when reverse polarity
is detected.
2 2 2 4
2 5
3
7
5.) Standby LED Illuminates when the charger is in Standby Mode, the charger
is not charging or providing any power to the battery.
6.) Charge LED indicates the connected battery(s) state-of-charge.
7.) Mode LED Indicates the Charge Mode the charger is currently in. Push the
MODE button to cycle through charge Modes.
8.) [Press and Hold] Mode LED Mode button must be pressed and held for 3
seconds to enter the mode.
6
8