Uline H-6553 Mode D'emploi page 3

PANTS
1. By hand, fold pants lengthwise. Lay pants across
panels with display side facing down and top of
inseam laying over plastic hinge. (See Figure 7)
2. If necessary, adjust panels to align desired fold
locations with panel hinges. (See "Adjusting Table
Fold Width" on page 5.)
NOTE: If pant legs extend beyond unit, fold
pant hem by hand to be even with outer panel.
(See Figure 7)
3. Lift side panel with pant waist slightly up, then flip
panel on side of pant hem. (See Figure 8)
4. Flip waist-end panel. Fold is complete. (See Figure 9)
NOTE: Depending on pant, multiple pairs of
pants can be folded at the same time.
PAGE 3 OF 15
OPERATION CONTINUED
Figure 7
Figure 8
Figure 9
Top of inseam
0524 IH-6553