Uline RUBBERMAID H-3028 Mode D'emploi page 2

Figure 1
A
A
B
Figure 2
Figure 3
Handle Cutout
PAGE 2 OF 15
B
Top Cabinet Panel
Bracket
Front Locking Panel
ASSEMBLY
1. Slide legs onto bottom shelf. (See Figure 1)
IMPORTANT! Insides of legs are marked "A" or "B".
Corresponding legs must be installed on corners
diagonally from one another. (See Figure 1)
NOTE: Cutouts in plastic on bottom shelf
will help guide legs into position.
2. Attach casters using screws and Phillips screwdriver.
(See Figure 1)
NOTE: Ensure swivel casters are installed
on same end of cart.
3. Turn cart upright onto casters.
4. Place back panel between two legs on long side
of cart. (See Figure 2)
NOTE: Two plastic tabs will show on the outside
and one on the inside at either end of the
back panel.
NOTE: Back panel may fit loosely at this time.
5. Attach brackets to top cabinet panel using shelf
screws. (See Figure 3)
6. Slide front locking panel into top cabinet panel
between brackets. (See Figure 3)
NOTE: Ensure handle on front locking panel
nests into top cabinet panel handle cutout.
(See Figure 3)
0424 IH-3028