Télécharger Imprimer la page

R&G FP0249 Notice De Montage page 4

Publicité

Les langues disponibles

Les langues disponibles

Page 8 of 8
Placez l'autre protection crash (article 2) sur l'extrémité exposée de la barre de manière à ce
qu'elle recouvre l'entretoise comme indiqué sur le schéma d'assemblage.
Monter la rondelle (article 5) et l'écrou (article 6) restants du kit sur le filetage exposé.
Serrez uniformément l'écrou des deux côtés à l'aide de deux douilles de 13 mm et assurez-vous
que l'insert en plastique des deux écrous soit complètement engagé et que les filetages saillants
soient égaux des deux côtés.
Ne pas trop serrer – les écrous nyloc maintiennent l'ensemble
Vérifiez que les protections fourche soient bien fixées et maintenues fermement contre les
entretoises et ne tournent pas librement.
Après avoir utilisé la moto, vérifiez régulièrement le serrage des écrous (par exemple lors du
nettoyage de la moto.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if
they were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods
must be in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25%
of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges.
No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does
not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1
07/09/2021 (DM)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
racing.com
R&G
www.rg-racing.com
FP0249
Email:
info@rg-

Publicité

loading