Bosch 0603663C00 Notice Originale page 22

22 | English
You can also mount the measuring tool on the tripod using the adapter plate (3).
Working with the adapter plate (see figures B–C)
The adapter plate (3) makes it easier to accurately align the measuring tool with a refer-
ence point and enables you to quickly attach and detach the measuring tool.
The adapter plate (3) can be mounted on the holder (16) or tripod (11).
– Holder: Place the adapter plate with the 1/4" mount (1) on the screw (13) of the
holder and tighten it to secure it on the holder applying moderate force.
Note: Loosen the locking screw (14) of the holder if you want to change the position
of the measuring tool. If the adapter plate is turned without loosening the locking
screw, the adapter plate can become loose and the measuring tool can fall off.
– Tripod: Tighten the locking screw of the tripod in the 1/4" mount (1) of the adapter
plate.
Press the measuring tool into the adapter plate (3) so that the locking mechanisms of the
adapter plate engage in the holes on two sides of the measuring tool. The adapter plate
can be fastened to the bottom, back and top side of the measuring tool. Check that the
measuring tool is firmly secured.
When the adapter plate is mounted on the back, the height of the measuring tool can be
aligned. When it is mounted on the top or bottom, the measuring tool can be aligned
sideways. Turn the fine adjustment screw (2) of the adapter plate to align the laser line
with a reference point.
Laser Viewing Glasses (Accessory)
The laser viewing glasses filter out ambient light. This makes the light of the laser appear
brighter to the eye.
Do not use the laser goggles as protective goggles. The laser goggles make the
u
laser beam easier to see; they do not protect you against laser radiation.
Do not use the laser goggles as sunglasses or while driving. The laser goggles do
u
not provide full UV protection and impair your ability to see colours.
Maintenance and Servicing
Maintenance and Cleaning
Keep the measuring tool clean at all times.
Never immerse the measuring tool in water or other liquids.
Wipe off any dirt using a damp, soft cloth. Do not use any detergents or solvents.
The areas around the outlet aperture of the laser in particular should be cleaned on a reg-
ular basis. Make sure to check for lint when doing this.
1 609 92A 4RH | (06.11.2018) Bosch Power Tools