Bosch 0603663C00 Notice Originale page 19

Cross line laser
Max. altitude
Max. relative humidity
Pollution degree according IEC 61010-1
Laser class
Laser type
C
6
Divergence
Tripod mount
Batteries
Operating time, approx.
Weight according to EPTA-Procedure 01:2014
– Cross line laser
– Holder
Dimensions (length × width × height)
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct sun-
light).
B) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
The serial number (9) on the type plate is used to clearly identify your measuring tool.
Assembly
Inserting/changing the batteries
It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
Push the locking mechanism (10) in the direction of the arrow to open the battery com-
partment cover (7) and remove the battery compartment cover. Insert the batteries sup-
plied.
When inserting the batteries, ensure that the polarity is correct according to the illustra-
tion on the inside of the battery compartment.
If the batteries become weak, the laser lines will flash quickly for a few seconds.
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
Bosch Power Tools
English | 19
Quigo green
500−540 nm, <5 mW
25 × 5 mrad (full angle)
2 × 1.5 V LR3 (AAA)
65 × 65 × 65 mm
1 609 92A 4RH | (06.11.2018)
2000 m
90 %
2
B)
2
5
1/4"
>2 h
0.27 kg
0.20 kg