Publicité
Les langues disponibles
Les langues disponibles
4. COMPLETING THE CART ASSEMBLY
Parts Required:
1
x
Support Leg / Front (#13)
1
x
Support Leg / Back (#14)
8
x
Screw (#A)
8
x
Washer (#B)
8
x
Locking Washer (#C)
2
x
Screw (#D)
Installation:
•
Mount the front-left Support Leg to the Bottom Shelf using a screw,
locking washer, and washer. Using two screw (#D), secure the Front
Panel to the same Support Leg. Note 4A.
•
Install the back-left Support Leg to the Bottom Shelf using a screw,
locking washer, and washer.
•
Mount a Support Leg with Caster to the hopper end of the Main Barrel
using three screws, locking washers, and washers, through the three pre-
drilled holes. Install screws from the inside of the Main Barrel. Repeat
installation for second Support Leg with Caster. Note 4B.
NOTE: Once all screw for the cart are installed, then tighten secure.
•
Carefully, lift the grill into an upright position.
5. ASSEMBLING THE LID HANDLE
Parts Required:
2
x
Lid Handle Bezel (#5)
1
x
Lid Handle (#6)
Installation:
•
Remove the pre-installed hardware from the Lid Handle. From inside
the Main Barrel lid, insert one screw to protrude to the outside. Add a
Bezel on the screw, then hand-tighten the screw, locking washer, and
washer (from the inside) into the Lid Handle. Repeat same installation
for other end of Lid Handle.
6. SECURING THE LID STOPPER
Parts Required:
1
x
Lid Stopper (#4)
Installation:
•
Secure the Lid Stopper onto the top of the Main Barrel using the
pre-installed hardware on top of the Main Barrel.
4A
13
D
D
4B
14
13
5
6
5
5
6
4
A
C
B
A
C
B
9
Publicité
