Publicité
Les langues disponibles
Les langues disponibles
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Care for parts.
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. CONNECTING THE WHEELS TO THE LEGS
Parts Required:
1
x
Support Leg / Front (#13)
1
x
Support Leg / Back (#14)
1
x
Support Leg for Wheel / Front (#15)
1
x
Support Leg for Wheel / Back (#16)
2
x
Locking Caster Wheel (#24)
2
x
Wheel (#25)
2
x
Wheel Cotter Pin (#E)
2
x
Wheel Washer (#F)
2
x
Wheel Axle Pin (#G)
Installation:
•
Attach the Wheel to the Support Leg for Wheel by inserting the Wheel
Axle Pin through the Wheel, Support Leg hole, Wheel Washer, then secure
using the Wheel Cotter Pin. Repeat installation for the other Support Leg
with Wheel. Note 1A.
•
Install a Locking Caster Wheel to the bottom of a Support Leg by
hand-tightening into the hole. The Locking Caster Wheel is inserted
completely when it cannot rotate any further into the Support Leg.
Repeat installation for second Support Leg. Note 1B.
ASSEMBLY PREPARATION
USA: (480) 923-9630 | Canada (Toll Free): 1-877-942-2246
www.pitboss-grills.com
ASSEMBLY INSTRUCTIONS
1A
15
16
G
25
F E
1B
13
14
24
7
Publicité
