CHECKING THE WATER DISPENSER
LINE
A water dispenser
is just one of the helpful features on your new Samsung
Refrigerator.
To help promote
better
health, the Samsung
water filter removes unwanted
particles from your water. However, it does not sterilize or
destroy microorganisms.
You may need to purchase
a water purifying system to do that.
In order for the ice maker to operate properly, a water pressure of 20-125
psi (pound per square inch) is
required.
Under normal conditions,
a 170 cc (5.75 oz.) paper cup can be filled in 10 seconds.
If the Refrigerator
is installed in an area with low water pressure (below 20psi), you can install a booster
pump to
compensate
for the low pressure.
Make sure the water storage tank inside the Refrigerator
is properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet.
_
Water line installation kits are available at extra cost from your dealer. We recommend using a water supply
that
kit
contains copper tubing.
Connecting
to the water supply
line
1. First, shut off the main water supply line and turn the ice-maker
off.
2. Locate the nearest cold, drinking water line.
3. After connecting
the water supply to the water filter, turn your main water supply back on and flush four
or more gallons into a bucket to clear and prime the water filter.
Cold water
line
P,peo,amp
.......... _
_Water
line installation
kit
16 Setti]g Up
DA68-01812H.indb
16
2009.8.10
9:4:1SIAM