Danby Designer DDMW01440WG1 Manuel Du Propriétaire page 11

OPERATING INSTRUCTIONS
FIRST TIME USE
When the microwave is plugged in for the first time
it will beep and the display will show "1:01" and
"CLOCK". Use the number pad to enter the current
time and then press the clock button to confirm.
When setting the cook timer, the microwave will
return to standby mode if there is no input within 25
seconds.
During operation:
• Press the Start/+30SEC button to begin
operation.
• Press the Stop/Clear button once to pause a
program and twice to cancel a program.
• The microwave will beep four times and display
"END" at the end of a cooking program. The
microwave will continue to beep every two
minutes until the door is opened or the Stop/
Clear button is pressed.
SETTING THE CLOCK
The clock can be set as a 12 or 24 hour clock. Press
and hold the Clock/Timer button for 3 seconds
to choose a 12 hour clock, then press it again to
choose a 24 hour clock.
To set the current time:
1. Press the Clock/Timer button.
2. Use the number pad to enter the current time.
3. Press the Clock/Timer button to confirm.
During operation, press the Clock/Timer button to
see the current time.
Note: If the set time exceeds the allowable range,
the microwave will return to reset state after
pressing the Clock/Timer button.
During cooking, you can check the current clock
time by pressing and hold Clock/Timer button for
more than 3 seconds.
SETTING THE TIMER
1. In standby mode or during cooking, press
Clock/Timer button once.
2. Use number buttons to set desired time. The
longest time is 99 minutes 99 seconds.
3. Press Start/+30SEC button to confirm.
Note: When the countdown ends, the buzzer will
beep to remind you. You can check the countdown
time by pressing Clock/Timer button, if Stop/Clear
button is pressed when the display shows the time,
the function can be cancelled.
MICROWAVE COOKING
1. Press the Power button repeatedly to select the
power level.
2. Use the number pad to enter the desired cooking
time. The maximum time is 99 minutes and 99
seconds.
3. Press the Start/+30SEC button to begin
operation.
Press Power Button
Once
Twice
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
Note: If "PL0" is selected, the microwave fan will
run with no cooking function. This power level can
be used to remove odors from the oven.
Note: During cooking, press the Power button to
check the current power level.
10
Power (Display)
100% (P-100)
90% (P-90)
80% (P-80)
70% (P-70)
60% (P-60)
50% (P-50)
40% (P-40)
30% (P-30)
20% (P-20)
10% (P-10)
0% (P-00)