Operating Elements Of Transmitter And Model; Transmitter - Reely SKY MC 120 Notice D'emploi

Connect the flight battery (4) to the charger socket (5) in the correct polarity. Observe the plug contour for this. If the battery is not defective
(high-Ohmic/interrupted) and mains supply is warranted, charging commences. This is indicated by the two red LEDs (3 = charge indicator).
The following LED displays are possible:
The red LED is permanently lit:
The red LED flashes:
Red LED off:
Individual battery cells of a battery pack are usually different. The USB charger has tow separate chargers integrated. Therefore,
it is possible that a battery cell is already charged (LED off) and the other battery cell is still being charged (LED on). Wait until
both LEDs have gone out before unplugging the battery.
The plug at the flight battery must be connected in a special manner. Therefore, the flight battery cannot be charged with
conventional LiPo chargers. Therefore, use the included USB charger from the delivery only to charge the flight battery.

9.

Operating Elements of Transmitter and Model

a) Transmitter
1 Button on/off
2 Button for channel selection
3 Control stick left (motor speed and yaw)
4 Yaw trimming
5 Control stick right (roll and pitch)
6 Pitch trimming
7 Roll trimming
40
The charging process is running
Defective battery and/or bad contact of the plugs
Charging end is reached or no rechargeable battery or a fully charged battery is connected
Figure 4