Philips HU4814 Mode D'emploi page 11

Refill water
Water level can be observed through
the transparent water tank window.
1
Switch off the humidifier and unplug
it.
2
Remove the upper unit by holding it
at both sides (fig. b).
3
Fill the water tank with cold tap
water until water reaches the
maximum water indication level
(fig. f).
Note
•
When filling water, do not exceed the
maximum water level, or water might
leak from the drain hole and air inlets.
•
Do not shake the water tank when
moving it, or water might leak from the
drain hole and air inlets.
•
Do not fill water through the air outlets
on top of the humidifier.
4
Place the upper unit back onto the
water tank.
5 Clean your
humidifier
Note
•
Always unplug the humidifier before you
clean it.
•
When pouring water from the water
tank, make sure to pour water from the
opposite side of the drain hole and air
inlets.
•
Never use abrasive, aggressive, or
flammable cleaning agents such as
bleach or alcohol to clean any part of
the humidifier.
•
It is normal to have dust inside upper
unit of the appliance after using it for a
while. User cannot clean it by himself.
Please contact local service center for
support.
Clean the body of the
humidifier
Regularly clean the inside and outside
of the humidifier to prevent dust from
collecting.
1
Wipe away dust with a soft dry cloth
from the body of the humidifier.
2
Clean the air inlet and the air outlet
with a soft dry cloth.
Clean the water tank
Clean the water tank every week to
keep it hygienic.
1
Take out the humidification filter
and the filter support.
2
Fill the water tank for 1/3 with water.
3
Add some mild washing-up liquid
to the water in the water tank.
EN
9