Kinetico Water Systems SMF Serie Guide D'utilisation page 11

S S :
tep ix
Check Installation:
To install cartridge: Locate notch above and align with head, push upwards and turn clockwise.
FEATURES AND BENEFITS
• Quick Change Cartridge
• Economical Operation
• Improves Taste and Odor
• Reduces:
- Sediment
- Chlorine (NSF tested)
- Chloramine
- Scale Build-up
- Microorganisms (virus and bacteria)
- VOC
- Lead
System has been tested and certifi ed
by NSF International against NSF/
ANSI Standard 42 for the reduction
of Chlorine and Taste & Odor.
KINETICO ADVANCED CARBON MEDIA and SUPERIOR
ULTRAFILTRATION
- Uniquely engineered, ultra-high porosity, catalytic carbon creates an extraordinarily large
active surface area for removing contaminants.
4. Close flush valve(s).
- 100% binder-free, gas-activated carbon maximizes capacity for longer-lasting cartridges.
5. Plug/turn equipment ON. Start drawing water from equipment to remove - Vortex fl ow combines turbo fl ow and radial fl ow to increase contact time, minimize
pressure drop and fully utilize media fi ltration capacity for maximum e ciency.
remaining air from the system water lines. Keep water running for approximately
- Adsorptive technology consisting of 400 layers of proprietary nano-alumina fi bers with
one minute until only water without air flows through. If possible/applicable, run
electrostatic properties inhibits scale formation and reduces contaminants such as lead,
carbonated water.
VOC, bacteria (99.99%) and heavy metals.
Do not use on water that is microbiologically unsafe or of unknown quality without adequate disinfection before or
after the system.
S S :
tep even
Use permanent marker to record the installation date on the date label.
USA patent 8,702,990, 8,701,895, 8,501,005, 7,429,326, 7,229,552
Performance of the water treatment unit may vary based on local water conditions.
1. Turn on water.
Multi-Purpose Filtration Cartridge
2. Slowly turn inlet ball valve to ON position, allowing
water to fill filter system. Verify that there is no leak
between filter head and cartridge.
3. Open flush valve for 30-60 seconds to verify water
flow and leak issues. Make sure that the water is clean
and free of air bubbles.
For split twin system, flush water from both flush valves
filtration performance, capacity and high flow rate:
www.kinetico.com
Recommended fi lter replacement is every 12 months.
INSTALLATION DATE:_______________
Kinetico SMF Series Water Filtration System
QCM 350+
• Rated Capacity: 20,000 gal.
• Flow Rate: 1.7 gpm
• Min/Max Pressure: 40-100 psi
• Min/Max Temp: 40˚-100˚ F
• Inlet-Outlet Size: 3/4" NPT
TECHNOLOGY
11
SPECIFICATIONS
guarantee the best
Part No. 16502