BorMann BAT6105 Mode D'emploi page 5

TROUBLESHOOTING
• If any of the following problems appear while the tool is in use, turn it off and disconnect it from the air supply immediately. Failure to heed this warning will
result in serious personal injury.
• Disconnect the tool from the air supply before making any adjustments.
• When replacing O-rings or the cylinder, lubricate with air tool oil before reassembly.
Problem
The tool runs at normal speed but loses
speed under load
The tool runs slowly. Air flows slightly from
exhaust
The tool does not work. Air flows normally
from exhaust
The tool will not shut off
Note: Repairs should only be carried out by a qualified person.
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the
products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be included
in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer shall
not be liable for injuries and damages resulting from the use of non-conforming equipment.
Possible cause
1. Motor parts are worn.
2. The clutch is worn or sticking due to lack of
lubricant.
1. Motor parts jammed with dirt particles.
2. Power regulator is in the closed position.
3. Dirt is blocking the air flow.
1. One or more motor vanes stuck due to
material build up.
1. O-rings in the throttle valve are dislodged
from the seat inlet valve.
WWW.NIKOLAOUTOOLS.GR
Solution
1. Lubricate the clutch housing.
2. Check for excess clutch oil. Clutch cases need only
be half full. Overfilling can cause drag on high speed
clutch parts.
Grease lubrication: Heat usually indicates insufficient
grease in chamber.
1. Check air inlet filter for blockage.
2. Pour air tool lubricating oil into air inlet as per
instructions.
3. Repeat above as needed.
1. Pour air tool lubricating oil into air inlet.
2. Tap motor housing gently with plastic mallet.
1. Replace O-rings or send the tool to a service center
for repairs.
E N
5