BorMann BAT6105 Mode D'emploi page 4

E N
• Use the proper lubricant in the air line lubricator. The lubricator should be of low air flow or changing air flow type, and should be kept filled to the correct
level. Use only recommended lubricants, specially made for pneumatic applications. Substitutes may harm the rubber compounds in the tool's O-rings and
other rubber parts.
• If a filter/regulator/lubricator is not installed on the air system, the tool should be lubricated at least once a day or after 2 hours of work with 2 to 6 drops of
oil, depending on the work environment, directly through the male fitting in the tool housing.
SPECIFICATIONS
OPERATING INSTRUCTIONS
Loading and operation
1. Only use sockets which are specifically designed for use with the tool.
2. Connect the tool to the air hose.
3. Holding the tool with the right hand, set the sleeve cover into a bolt and pull the trigger to start working.
• The flow of air may be regulated by adjusting the flow valve at the base of the handle.
• Ensure the air supply is clean and does not exceed 90 psi while operating the tool. Too high an air pressure and unclean air will shorten the product life due
to excessive wear, and may be dangerous causing damage to property or personal injury.
• Keep children away from the tool and from the workplace.
• DO NOT apply additional or excessive force to the tool in order to remove a nut.
• DO NOT allow the tool to run continuously for an extended period of time as this will shorten its life.
MAINTENANCE
• The tool must be inspected periodically and worn or broken parts must be replaced in order to keep the unit operating safely and efficiently.
• Disconnect the tool from the air supply before changing accessories, servicing, or performing maintenance.
• Only use the tool after replacing or repairing the damaged parts or accessories.
• Use only genuine replacement parts and accessories that are compatible and suitable for use with the tool.
• Repairs must be performed by a qualified service technician.
• Lubricate the tool daily with a few drops of air tool oil dripped into the air inlet.
• Loss of power or problematic operation may be due to the following:
- Excessive drain on the air line.
- Moisture or blockage in the air pipe.
- Dirt accumulation on parts of the tool may also reduce performance.
• If the tool has an air strainer (located in the area of the air inlet), remove the air strainer and clean it.
• When not in use, disconnect the tool from the air supply, clean the tool and store it in a safe and dry place that is inaccessible to children.
4
Technical Data
Model
Torque
Square drive
WWW.NIKOLAOUTOOLS.GR
BAT6105
68 Nm
1/2''