Amica 2013CCTs Serie Notice D'utilisation page 87

INSTALLATION
Assembly of the gasket
Depending on the model, the seal is already installed at the factory (fig.1)
If the seal has not been fitted at the factory, proceed as follows:
Before installing the hob in the cut-out worktop, the gasket is to be attached to the back of
the hob (pic. 2)
To do this, first peel off the protective film from the self-adhesive seal and glue the gasket as
close as possible to the outer edge of the hob (fig. 3,4).
Do not install the appliance without the
foam gasket.
Then turn the hob over insert it into the cut-out of the
furniture. Align the positioning symmetrically so that the
distances between the hob and the countertop is the
same on all sides. (fig. 5)
1 2
5
87
3
U S Z
C Z E K L E
L K A J
4