GE Profile ENERGY STAR PFQ97HS Guide De L'utilisateur Et Instructions D'installation page 24

UNPACKING THE COMBO
Recycle or destroy the carton and
WARNING
plastic bags after the Combo is
unpacked. Make materials inaccessible to children.
Children might use them for play. Cartons covered
with rugs, bedspreads or plastic sheets can become
airtight chambers causing suffocation.
1. Cut and remove all packaging straps.
2. Remove carton, top packaging, and corner posts.
Do NOT remove shipping bolts.
3. Carefully lay the Combo on its back and remove the
bottom packaging. Do NOT lay the Combo on its front,
sides, or top. If a Riser is to be added, install with the
Combo on its back before proceeding to the next step.
4. Carefully return the Combo to an upright position.
5. Carefully move the Combo to within 4 feet (122 cm)
of the final location.
6. Remove the following from the back side of the Combo:
4 bolts
4 plastic spacers (including power cord retainers and
rubber grommets)
Bracket and the screws fastening it to the Combo
NOTE: Do NOT remove the screw or clip holding the
hose.
Spacer
Bolt
Retainer
Bracket
24
Installation Instructions
UNPACKING THE COMBO (cont.)
Watch this video for more step by
step instructions on the importance
of removing the shipping bolts before
operating your Combo.
7. Insert shipping bolt hole covers into shipping bolt
holes.
IMPORTANT:
• Failure to remove all shipping support hardware can
cause the Combo to become severely unbalanced.
• Save all shipping support hardware for future use.
If you must transport the Combo at a later date,
you must reinstall the shipping bolts and spacers
to prevent shipping damage. The brackets are not
required and can be discarded.
NOTE: Consider recycling options for your appliance
packaging material.
49-3000353 Rev 6