GE Profile ENERGY STAR PFQ97HS Guide De L'utilisateur Et Instructions D'installation page 19

Care and cleaning
Sharp Edges – Although it is unnecessary to perform this type of maintenance, to reduce the risk
WARNING
of injury, use care when cleaning the condenser or evaporator coil fins.
Exterior
The Combo control panel and finishes may be damaged by some laundry pretreatment and stain remover products.
Immediately wipe off any spills with a sanitizing wipe or non-abrasive damp cloth. Apply these products away from the
Combo. Do not wipe an exterior surface with abrasive cloths or cleaners. Damage to your Combo caused by these
products is not covered by your warranty.
Interior
Clean around the Combo's door opening, flexible gasket (including attached hoses) and door glass. These areas
should always be clean to ensure a watertight seal. It is recommended to wipe down the gasket thoroughly with a
disinfecting wipe to remove lint and other debris. A Self Clean Cycle can also be run for this purpose.
Filter Compartment
Periodically clean inside the filter compartment by
removing the filter frame. Use either a vacuum with
a crevice tool attachment or the Appliance Brush Set
(Part # PM14X10056). When cleaning, be careful not to
damage or bend the fins of the evaporator which is just
inside the area to the right of the opening.
Filters
The filter compartment contains a two-stage housing consisting of a Lint Filter and a Foam Filter. To access the
filters, slowly remove the filter frame from the Combo by pulling straight out and pressing on the tab to release.
Lint Filter: Clean the lint filter after every 5th dry cycle
by running your fingers across it. A helpful reminder will
show on the display. A waxy buildup may form on the
lint filter from using fabric softener sheets. To remove this
buildup, wash the lint filter in warm, soapy water. Dry
thoroughly and replace.
Release
Tab
Vacuum the lint from the filter frame and inside the filter opening if you notice a change in dryer performance.
NEVER OPERATE THE COMBO WITHOUT ITS FILTERS IN PLACE.
49-3000353 Rev 6
Lint Filter
Your Combo will suggest when to clean the lint filter and foam filter.
The Appliance Brush Set can be ordered through
GEApplianceparts.com.
Foam Filter: Clean the foam filter periodically (approximately
every 50 cycles) or when notified by the Combo. Open
the filter frame and remove the foam filter. Rinse filter
and discard lint. Insert the foam filter back into the filter
frame using the locating tabs for guidance. Ensure the
filter is properly aligned in the frame and fully snap the
foam frame to the lint filter.
NOTE: If the foam is torn or deformed do not reuse it.
A replacement foam, part WH01X35719, can be ordered
through GEApplianceparts.com.
Foam Filter
Tilt
Open
Foam
Frame
Locating
Tabs
19