Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CLEANING ALUMINUM GREASE FILETS / BLOWER SAFETY GRILLS
•
The aluminum filters fitted in the factory are intended to filter out residue and grease from cooking.
They need not be replaced regularly, but must be kept clean. Filters should be cleaned after every
30 hours of use.
•
Remove and clean by hand or dishwasher. Spray Formula 409
and leave the filter soak if heavily soiled. Dry the filters and re-install them before using the range
hood.
Drain grease from grease container before the grease and residue overflow.
REPLACING FILTERS
Worn out filters can be replaced by contacting ELEGANCE or an authorized dealer.
A filter with punctured or broken mesh, or a bent or broken frame should be replaced.
REPLACING GU10 LED TYPE LIGHT FIXTURES
•
Ensure that the Range hood is unplugged or that the circuit breaker is off.
•
Ensure that the lights have cooled. Gently push on the light and turn clockwise all while maintaining
pressure on the light. Insert the new light by turning counterclockwise.
•
Plug in the range or turn the circuit breaker back on and verify the light functions properly.
REPLACING G4 TYPE HALOGEN LIGHT BULBS
•
This range hood uses 20W 12V (G4) halogen light bulbs.
•
Before replacing a light bulb, make sure the range hood is unplugged or the breaker has been
turned OFF. Do not touch the lights until they have cooled.
•
Place a small flathead screwdriver between light housing and lens cover. Carefully and gently pry
up the lens cover. Remove the old halogen light bulb by pulling in the direction of the wavy arrow
as illustrated below. Do not touch the new light bulb with your bare hands.
•
Reverse the steps to install a new halogen light bulb. After the new bulb has been installed, turn
ON the breaker and the range hood to test that the new light bulb is working properly.
If you need replacement parts, we recommend that you only use genuine parts. Our accessories
and parts are engineered and designed specifically for this series of range hood, with each one
rigorously tested to ensure the utmost in durability and reliability.
DO NOT touch bulbs until they have been switched off and
have cooled. Touching hot bulbs can cause serious burns.
BURN HAZARD !
Light bulbs become extremely hot.
or equivalent degreasing agent
©
ELEGANCECANADA.CA
16
Publicité
Table des Matières
