Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Read all Instructions before Installing and operating this range hood
The installation instructions in this guide are intended for qualified installers, service technicians or persons
with similar qualified background. Installation and electrical wiring must be done by qualified professional
and in accordance with all applicable codes and standards, including fire-rated construction. The range
hood may have very sharp edges, please wear protective gloves if it is necessary to remove any parts
for installing, cleaning or servicing. Activating any switch ON before completing the installation may
cause ignition or an explosion. Due to the size and weight of this range hood, it is recommended that two
people handle the installation.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY
•
This range hood is for general ventilating use
only. DO NOT use the exhaust hazardous or
explosive materials or vapors.
•
Before servicing or cleaning the unit, switch
power to OFF at the electric panel and lock
it to prevent power from being switched on
accidentally.
•
Clean grease-laden surface frequently ; to
reduce the risk of fire and to disperse air
properly, make sure to vent air to the outside.
DO NOT vent exhaust into spaces between
walls, crawl spaces or into ceiling, attic or
garage.
•
ALWAYS vent ducted fans to the outside.
•
Use only metal ductwork.
•
Always ground the unit.
TO REDUCE THE RISK OF A STOVE-TOP GREASE FIRE
•
Keep fan, filters, exhaust and grease-laden
surfaces clean; grease should not be allowed
to accumulate anywhere in the range hood.
•
Always turn range hood ON when cooking,
espacially when cooking at high heat or with
an open flame.
•
Use the highest heat setting only when
necessary.
•
To prevent back drafting, ensure there is
sufficient air for proper combustion and
exhausting of gases through the duct.
•
When cutting or drilling into a wall or ceiling,
take care not to damage electrical wiring or
other hidden utilities.
•
Ensure that all electrical wiring is properly
installed, insulated and grounded.
•
Clean old duct work or replace it if necessary
to avoid the possibility of a fire due to old
accumulation of grease.
•
Check all joints on duct work to ensure proper
connections. Tape all joints properly.
•
Use this unit only in the manner intended by
the manufacturer. If you have question, contact
ELEGANCE.
•
Never leave the cooking curface unattended
at a high setting; boiling liquids cause smoke
and grease may ignite. Heat cooking oils
slowly on low or medium settings.
•
Clean the ventilating fan frequently.
•
Always use appropriate cookware and
properly sized ustensil.
•
Always use cookware appropriate for the size
of the surface element.
ELEGANCECANADA.CA
2
Publicité
Table des Matières
